Supermicro 1026GT-TF Manuale Utente Scaricare il pdf (Pagina 62)

6-2

SUPERSERVER 1026GT-TF Series User's Manual

Figure 6-1. Chassis: Front and Rear Views

6-2 Control Panel

The control panel (located on the front of the chassis) must be connected to the

JF1 connector on the serverboard to provide you with system status indications. A

ribbon cable has bundled these wires together to simplify the connection. Connect

the cable from JF1 on the serverboard to the appropriate header on the Control

Panel PCB (printed circuit board). Make sure the red wire plugs into pin 1 on both

connectors. Pull all excess cabling out of the airﬂ ow path.

The control panel LEDs inform you of system status. See "Chapter 3: System In-

terface" for details on the LEDs and the control panel buttons. Details on JF1 can

be found in "Chapter 5: Advanced Serverboard Installation."

6-3 System Cooling

Eight 4-cm counter-rotating fans provide the cooling for the system. Each fan

unit is actually made up of two fans joined back-to-back, which rotate in opposite

directions. This counter-rotating action generates exceptional airﬂ ow and works to

dampen vibration levels.

It is very important that the chassis top cover is properly installed and making a

good seal in order for the cooling air to circulate properly through the chassis and

cool the components.

Control Panel

Hot-Swap Drive Bays (6)

PCI Slots

COM Port

Power Supply

USB Ports

LAN Ports VGA Port

Dedicated IPMI LAN Port

Note: the number of PCI slots available depend on the presence of GPUs in the

server model.

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 103 104

Nessun commento

Supermicro 1026GT-TF Manuale Utente Pagina 62